Philips 42PFL5606S/98, Service Manual

Page: 12 / 70

Mechanical Instructions EN 12 TPM8.3A LA 4.
2011-Nov-11
4.3.4 Speakers
1. Unplug speaker connectors from the SSB.
2. Release speaker cables from the clamps.
3. Take the speakers out.
When defective, replace both units.
4.3.5 EMC Board
1. Unplug the connector from the EMC board.
2. Remove all fixation screws from the EMC board.
When defective, replace both units.
4.3.6 IR/LED Board
1. Unplug the connectors from the IR/LED board.
2. Release the clips that hold the board and take it out from
the bezel.
When defective, replace both units.
4.3.7 LCD Panel
1. Release the LVDS connector from the LCD panel.
2. Take out the speakers, as described earlier.
3. Remove the MEMC board as described earlier.
4. Remove the IR/LED board as described earlier.
5. Release all tapes that fit cables to the back side of the LCD
panel.
6. Remove all fixation screws of the sub frames on the sides
of the LCD panel.
7. Lift the sub frames, together with the mounted panels from
the LCD panel and put it aside.
8. Lift the LCD panel from the front bezel.
When defective, replace the whole unit.
4.4 Set Re-assembly
To re-assemble the whole set, execute all processes in reverse
order.
Notes:
•
While re-assembling, make sure that all cables are placed
and connected in their original position. See
Figure 4-1 and
Figure 4-2 .
• Pay special attention not to damage the EMC foams on the
SSB shields. Ensure that EMC foams are mounted
correctly.