EN-10
3�5 Manage cables
Route your mains cord, antenna cable and all
other device cables through the cable holder
(1) at the back of the TV Monitor.
1
3�6 Insert the remote control
batteries
Slide the battery cover off the back of the
1.
remote control.
Insert the two supplied batteries (Size AAA,
2.
Type LR03). Be sure the + and - ends of the
batteries line up with the markings inside
the case.
Slide the cover back into position.
3.
Note
D
Remove the batteries if not using the
remote control for an extended period of
time.
3�7 Switch on the TV Monitor
The first time you switch on, check that the
mains cord is properly connected. When ready,
then press
POWER
on the side.
Note
D
Certain models require you to press and
hold
POWER
for up to two seconds. Your
TV Monitor may take up to 15 seconds to
start.
First time setup
3�8
When you turn on the TV Monitor set for the
first time, a menu is displayed on screen. This
menu prompts you to select the Country and
Language for the menus:
If the menu is not displayed, press the
MENU
key to display the menu.
Press
1.
Î
or
ï
to select your language, and
press
OK
to confirm your choice.
Press
2.
Î
or
ï
to select your country, and
press
OK
to confirm your choice.
The search starts automatically. All available
TV programmes and radio stations are
stored. This operation takes a few minutes.
The display shows the progress of the
search and the number of programs
found. At the end of the search, the menu
disappears.
Note
D
If no programme is found, consult
the possible solutions see section 9
troubleshooting.
If the transmitter or cable network sends
the automatic sort signal, the programs will
be numbered correctly. In this case, the
installation is complete.
If this is not the case, use the
3.
Channel
setting
menu to number the programs
correctly.
Summary of Contents for 220TW9FB
Page 43: ...EN 43 EN ...
Page 44: ...EN 44 Monitor Monitor Monitor ...
