
3.1. Include Device
Add a Z-Wave device to the Z-Wave network, the controller should
include it. But before you execute the include operation, please make
sure that device is not be included to other network. If it is, please
operate the exclude procedure first.
To execute the include operation; please press the “Include” button.
The all buttons of the main function part will be disabled. And the
controller will into to inclusion mode. If you want to abort the include
operation, please press the “Abort” button in the controller function
part.
Figure
5
Controller into inclusion mode
Now press the learning key on the device, usually the Z-Wave devices
made from Philio, press the learning key three times the device will
into the learn mode. If the controller got that message, the UI will
show a progress bar, the dongle will query some information from the
device.
Figure
6
Query the information from the device
After all done, the all buttons of the main function part will recover,
and in the device list part will add a new device record. The message
part will show a new device was added, and which node id it is.
6