IMPORTANT
Installation must be performed by skilled technicians who are informed about the
standards and technical requirements of the appliance and its proper installation.
Check your local codes as they apply to your situation. If the house wiring is of
aluminum, consult with an electrician about proper wiring methods.
Before proceeding with the installation, TURN OFF THE POWER TO THE LIGHTING
CIRCUIT AT THE CIRCUIT BREAKER OR FUSE BOX TO AVOID ELECTRICAL
SHOCK.
For Instruction to http://www.philio-tech.com
Danger
Danger of electrocution!
All works on the device may be performed only by a qualified and licensed
electrician. Observe national regulations. Any works introducing changes into the
configuration must be always performed with disconnected voltage.
Choosing a Suitable Location
1. Do NOT place the module/device direct under sunlight, in a humid place or in
any location where they may contact moisture, dirt, dust.
2. Do NOT place the module/device where exists combustible substance or any
source of heat, fires, radiators, boiler etc.
3. When the module/device be used, the module/device might get warm. This is
a normal condition.
4. After putting it into use. The body of Module will bexome a little bit hot of
which phenomenon is normal.
Adding to Z-Wave
™
Network
In the front of the device, there is an on/off button with an LED light indicator which is
used to dim on and off, carry out inclusion, exclusion, reset or association. When
powered for the first time, the device’s LED light will flash on and off alternately and
repeatedly at 1 second intervals. This implies that no node ID has been assigned,
and auto inclusion is ready to start.
3
