Philco PLD 1061M, User Manual

Page: 7 / 26

EN - 5
07/2014 Copyright © 2014, Fast ČR, a. s.
Electrical connection
• Technical specifi cations of your washing machine: 220-240 V ~ 50 Hz.
• A special grounding plug is attached to the power cord of your washing machine. This plug must be
fully inserted into a grounded power socket (with 10A). The electrical fuse or circuit breaker to which the
washing machine is connected should be rated at 10A. If you do not have such sockets and fuses in your
home, have them installed by a qualifi ed electrician.
• Our company takes no responsibility for whatever damages caused by using the washing machine without
grounding.
Water supply connection
• Depending on the functions of your washing machine, the washing machine is equipped with either a
single water inlet (cold) or a double water inlet (cold/hot). The hose with the white end is intended for the
cold water inlet and the hose with the red end is intended for the hot water inlet (on washing machines
with a hot and cold water inlet).
• So that water does not leak from the connection points, the hose kit also includes 1 seal (for washing
machines with a cold water inlet) or 2 seals (for washing machines with hot and cold water inlets). Install
these seals on the end of the water inlet hose that is to be connected to the tap.
• Connect the hose with the white end to the water inlet valve with the white fi lter and the hose with the red
end to the water inlet valve with the red fi lter (the second mentioned option applies to washing machines
with a hot and cold water connection). Tighten the plastic connecting parts using your hand. A qualifi ed
plumber will provide a safer connection.
• The water pressure of 0.1 - 1 MPa in your water tap will ensure a more effi cient operation of your washing
machine (the pressure of 0.1 MPa equates to a fl ow rate of more than 8 litres of water per minute from a
fully open tap).
• After the connections are complete, check that the connections do leak by fully opening the tap.
• Check that the supply hoses are not bent, broken or cracked.
• Connect the supply hose to a 3/4" threaded water tap.
• If the washing machine has a dual water inlet (for hot and cold water), the temperature of the hot water
should not exceed 70 °C.