EN - 30
03/2012
Copyright © 2012, Fast ČR, a. s.
PART 7: PREVENTION OF MINOR MALFUNCTIONS
Technical
problems
Problem
Possible causes
What to do
The
dishwasher
will not
start.
A burned fuse or the
circuit breaker is off .
Replace the fuse or turn on the circuit breaker. Disconnect
any other appliances sharing the same circuit.
Power source is not
turned on.
Check that the dishwasher is turned on and the door is shut
properly. Check that the power plug is correctly connected
to the power socket.
Water pressure is low.
Check that the water supply is correctly connected and
whether it is open.
The dishwasher door is
not closed properly.
Check that the door is closed properly and secured with
the latch.
The
dishwasher
is not
draining
water.
There is a knot on the
drain hose.
Check the drain hose.
The fi lter is clogged.
Check the coarse fi lter
(see section "Cleaning the fi lters").
The kitchen sink is
clogged.
Check the kitchen sink and ensure that it drains well. If the
problem is an incorrectly draining sink, fi rst call a plumber
and only then the service technician.
General
problems
There are
suds in the
dishwasher.
An incorrect
dishwashing detergent
was used.
Use only special detergents for dishwashers to prevent the
formation of suds. If this occurs, open the dishwasher and
allow the suds to evaporate. Pour 0.4 l of cold water into
the dishwasher. Close the dishwasher to the latch and then
start the rinse cycle to drain the water.
Repeat if necessary.
The rinsing
aid has spilled out.
Always immediately clean the rinsing aid.
There are
stains inside
the
dishwasher.
You have used
a dishwashing
detergent with dyes.
Use a dishwashing detergent not containing dyes.
There is
a white fi lm
inside the
dishwasher.
The white fi lm is
caused by hard water
minerals.
Clean out the inside of the dishwasher using a damp
sponge with detergent. Use rubber gloves. To prevent the
risk of the formation of suds never use any other detergents
than those designed for use with dishwashers.
On
the cutlery
there are
rust stains.
The aff ected items
are not resistant
to corrosion.
After refi lling the salt
you did not start any
program.
Salt particles got into
the washing cycle.
After adding salt always run a quick wash without dishes
and without the Turbo function activated (if available).
Loose water softener lid
Check the lid. Check that it is pulled tight.
