12
Step 3. Operation
Press up or down to set a suitable flow of water.
Press enter (PUMP 1 only) to display the current battery voltage.
To monitor water temperature (in degrees centigrade) press enter repeatedly until
tp is displayed.
Press enter again to monitor TDS reading.
A TDS reading greater than 50ppm will display HI (high).
Press enter again to return to the current flow rate.
To turn the controller off, press and hold enter.
,
To start filling the tank press and hold the up and down buttons. This will activate
the solenoid valve allowing water to fill the tank until the float switch detects that the
tank is full.
Operation - Tank Filling (When FOd is OFF)
+