PFT PFT RITMO, Operating Instructions Manual

Page: 44 / 48

PFT RITMO powercoat 110V Operating Instructions Last updated 12.2006
Knauf PFT GmbH & Co. KG
44
Program Group Parameters Frequency Power Flex RITMO 110V 1Phase
Parameter Display
P031 Motor NP Volts 230 V Set to the motor Nameplate
rated volts
P032 Motor NP Hertz 50 Hz Set to the motor Nameplate
rated frequency
P033 Motor OL Current 5.8 A Set to the maximum allowable
motor current
P034 Minimum Freq 20 Hz Sets the lowest frequency the
drive will output continuously
P035 Maximum Freq 87 Hz Sets the highest frequency the
drive will output
P036 Start Source
2 = 2-Wire
2 Sets the control scheme used
to start the drive
P038 Speed Reference 2 Sets the source of the speed
reference to the drive
P039 Accel Time 1 1.5 sec Sets the rate of accel for all
speed increases
P040 Decel Time 1 1.5 sec Sets the rate of decel for all
speed decreases
P041 Reset To Defaults
0= Idle State
1= Reset Defaults
0 Resets all parameter values to
factory defaults
A055 Relay Out Sel 2 Motor Running