06HULHV__5HY__HPDLOSVG#SÁRZFRP
6HFWLRQ_
Section 9 |
Sequence of Operation
www.pflow.com
P 414 352 9000
F 414 352 9002
6720 N. Teutonia Ave.
Milwaukee, WI 53209
ASME B20.1 defines a qualified person as a person who, by possession of a
recognized degree or certificate of professional standing, or by extensive knowledge,
training, and experience, has successfully demonstrated his/her ability to solve
problems relating to the subject matter and work.
Personnel to carry out work on the VRC must exclusively be qualified personnel
who - based upon their education, experience, instructions as well as knowledge
concerning relevant standards and provisions, accident prevention, regulations
and operating conditions - have been authorized by the person being responsible
for safety, to carry out the activities described in these instructions and who - when
doing so - are in a position to recognize possible risks early and to avoid them.
Before You Begin
Read this entire manual before operating the Vertical Reciprocating Conveyor
(VRC).
Service must be performed by qualified and trained service technicians only.
NOTICE
z
Stay within the rated lift capacity.
z
Make sure all safety devices are in place and operable before using the
equipment. If any safety device is missing or inoperable, immediately
remove the equipment from service.
z
Falling hazard! Always make sure the carriage is present before walking
through doorways.
z
Keep clear of unsupported platforms. Stay out of the area under a raised
platform. If a maintenance operation requires the carriage to remain in
the raised position, physically secure the carriage with a maintenance pin,
DeckLock system, chains, cables, or with a maintenance operation option
for the platform.
z
Passengers are not permitted. Riding may result in death or serious
personal injury.
z
Allow only competent adults who have been properly trained in the safe
use of this equipment to operate it.
z
This equipment can be dangerous if not used properly. Allow only properly
trained and authorized personnel to operate this equipment.
z
Close all gates before the carriage is moved. Never leave the lift unattended
with the gates in the open position. Never close gates when a person is on
the carriage or within the fenced area.
z
Place the load in the center of the lift platform to avoid shifting loads. Make
sure that any portion of the load does not overhang the perimeter of the
carriage. This could create an unstable load condition.
