Operating Manual DTS and DTI 6201C / 6301C Multi-Controller (MC) 086100014 © Pfannenberg GmbH
Page 17 / 43
GB
3.4.3
DTS cooling unit assembly (side attachment)
Item
Designation
Item
Designation
1
Holes
2
Device contour
3
Cut-out
Make cut-out for the DTS cooling unit
Requirements
-
All general requirements have been fulfilled; see
General assembly requirements
- The unit is de-energized.
Required tools and material
- Saw
- Use a switch cabinet cutter, if applicable
- Protective covers
Procedure
Use a protective cover to protect the switch cabinet from chips.
Provide the switch cabinet with cut-out (3) and holes (1). For the prescribed dimensions, refer to the figure
exterior view of the switch cabinet.
Deburr the cut edges.
Remove chips and assembly waste from the switch cabinet.
Cut-out and holes have been made.
Figure 9 - Switch cabinet exterior view
Holes for DTS cooling unit
Figure 10 - Switch cabinet exterior view
Cut-out for DTS cooling unit
1
1
3
2
