12 - 21
Adjustment
12
.05.19
Zeroing the main feed (rear feed dog)
on the PFAFF 939 U
Requiremen
t
With the stitch length set at "
0
", when the balance wheel is turned, there should be no
feeding motion of the main feed dog.
Fig. 12 - 20
●
Set the stitch length at "0".
●
Fit the open-ended spanner (width 27) to the torsion-spring collar
1
and use it to hold
regulating shaft
2
.
●
Loosen screw
3
.
●
While constantly turning the balance wheel, adjust the spanner on the torsion-spring
collar
1
in accordance with the
requirement
.
●
In this position, move adjustment crank
4
against the cast iron frame and tighten screw
3
.
●
Carry out a control in accordance with the
requirement
.
2
1
3
4
Summary of Contents for 3704-2/02
