Adjustment
2
15
.05
Basic position of the machine
Requirement
After being switched on the machine should position approx. 3 – 4 mm before t.d.c. take-
up lever.
●
Switch on the machine.
●
Press the
TE key
.
●
Select parameter
605
with the corresponding
+/- key
.
●
Press pedal forwards once briefly (machine positions in t.d.c. needle).
●
Hold clutch
1
(screws
2
) and bring the needle bar into the appropriate position by turning
the balance wheel.
●
Press pedal forwards again to re-check the position set.
●
Conclude the adjustment by operating the
TE key
.
The distance from the clutch
1
to the motor plate should be
3.5 mm.
In the direction of rotation the second screw of the clutch section
3
should be
on the surface of the motor shaft.
The clutch section
1
should be touching the 0-ring of the axial bearing.
2
1
3,5 mm
2
3
Fig. 15 - 01