Adjustment
33
000
007
Starting point = scale reference point
ON – OFF
OFF
With this parameter it is possible to
choose whether the scale reference
point is the starting point (ON) or the
zero point (OFF).
008
Speed for the "winding" function
500 2500
1500
This parameter is used to fix the speed
for the winding operation.
009
Via zero point to starting point after
end of sequence
ON –OFF
OFF
With this parameter it is possible to
choose that, after the end of the
sequence, the X-, Y-drive moves to the
seam starting point via the reference
initiators.
010
Via zero point to starting point after
number of program cycles
ON –OFF
OFF
Number of program cycles
1 - 100
With this parameter it is possible to
choose that, after a certain number of
program cycles, the X-, Y-drive moves
to the seam starting point via the
reference initiators.
011
Pedal mode
0 – 1
0
Switchover between level mode
(0) and flip flop mode (1).
012
Needle or balance wheel position in
0 - 360
11
degrees
013
NIS "needle in material" [°]
65 – 166
107
This parameter is used to set the NIS
signal. If the function is executed, the
position can be entered by turning the
balance wheel. If the position is altered,
the result is a change in the point of
time when the carriage is moved. The
access code is necessary for this
adjustment.
014
Thread trimming speed [min-1]
100 – 700
300
This parameter is used to fix the speed
for thread trimming.
Group
Parameter
Description
Setting
Set value
range