21
Mounting and commissioning the machine
8
.04
Switching the machine on/off
Fig. 8 - 04
2
1
Fig. 8 - 05
3
●
The machine will drive into home position after the controls have been booted.
In programs with obstacles, the prompt "
HOME MOVE CARRIAGE
SDSq, and the clamp
will have to be moved to the home position by hand (= needle in the rear left corner of
the clamp).
●
After shifting the clamp manually, press the "
Basic position
" button.
●
Carry out a test run, see Chapter
10
Sewing.
At fi rst commissioning of the machine, the zero points and
the potentiometer for motor speed reduction must be checked and set
(see chapter
8
.
05
and
8.06
)
.
●
To switch off the machine, turn main switch
3
to position "
0
".
●
Check air pressure on pressure gauge
1
and, if necessary, adjust air pressure with
adjusting knob
2
.
●
Turn main switch
3
to position "I"
HOME
MOVE CARRIAGE
HOME
PUSH HOME KEY
Summary of Contents for 3108-1/1306
