PEUGEOT Tweet, Workshop Manual

Page: 33 / 64

SERVICE OPERATIONS
31
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
- Remove the clutch linings (2), the upper
centring sleeve (3), the spring (4), and the
lower centring sleeve (5).
- Remove the 3 pins (6) from the variable
speed drive seat.
- Separate the fixed (7) and rotating
(8) flanges.
- Make sure surface of the plates in contact
with the belt does not show any cracks or
signs of abnormal wear.
„
Refitting the clutch lining assembly
- After checking the 2 lip seals (9) and the
2 O-rings (10) of the rotating flange (8)
are in good condition, grease the
governor seat 3 pins (6) (high
temperature grease) and assemble the
parts in reverse order to removal.
50 cc 125/151 cc
- Compress the clutch drive pulley and
driven pulley assembly with the tool P/N
752127.
- Compress the clutch and driven pulley
assembly using tool 758008 equipped
with the protection spacer P/N 801682.
- Tighten the nut (1).
Tightening torque: 55 Nm.
- Fit the clutch drive pulley and driven pulley assembly.
- Fit the clutch cover.
- Fit washer.
- Fit and tighten the nut.
- Tightening torque: 55 Nm.
Before fitting the clutch drive pulley and driven pulley to the input shaft, fit the belt into the
pulley bottom by opening the flanges by hand.
2 3
6
4 5
7
8
1
8
10
9