26
Access
With Keyless Entry and Starting
►
Insert the mechanical key (incorporated into
the remote control) into the lock to open the
vehicle.
►
Place the electronic key against the back-up
reader on the steering column and hold it there
until the ignition is switched on.
►
Switch on the ignition by pressing the
"
START/STOP
" button.
►
With a manual gearbox,
place the gear lever
in neutral then fully depress the clutch pedal.
►
With an automatic gearbox or drive
selector
, while in mode
P
, depress the brake
pedal.
If the fault persists after reinitialisation, contact
without delay.
Doors
Opening
From outside
►
After unlocking the vehicle or with the
Keyless Entry and Starting electronic key in the
recognition zone, pull the door handle.
From inside
►
Pull the interior opening control of a door; this
unlocks the vehicle completely.
With selective unlocking activated:
– Opening the driver's door unlocks
the driver's door only (if the vehicle has not
already been completely unlocked).
– Opening one of the passenger doors
unlocks the rest of the vehicle.
Closing
If a door is not properly closed, this
warning lamp comes on accompanied by
a message if the engine is running, and an
audible signal when the vehicle is travelling at
more than 6 mph (10 km/h).
Boot
Opening
►
After unlocking the vehicle or just the boot,
press the opening control and then raise the
tailgate.
Closing
►
Lower the tailgate using one of the interior
grab handles.
If the tailgate is not properly closed, this
warning lamp comes on accompanied by
a message, if the engine is running, and an
audible signal, if the vehicle is travelling at more
than 6 mph (10 km/h).
In the event of a malfunction or if you
the tailgate, have it checked by a PEUGEOT
to avoid the issue deteriorating and prevent
any risk of the tailgate dropping, potentially
causing serious injury.
Back-up release
To manually unlock the boot in the event of a
battery or central locking failure.
Unlocking
►
Fold the rear seats to gain access to the lock
from inside the boot.
