www.petsafe.net
15
To assure a proper fit, please follow these steps:
1. Make sure that the battery is not installed in the Receiver Collar.
2. Start with your pet standing comfortably (
5A
).
3. To make it easier to hear the warning tone, place the Receiver Collar on your pet with
the logo side of Receiver facing up.
4. Center the Contact Points underneath your pet’s neck, touching the skin.
You may need to trim the hair in the area of the Contact
Points. Never shave the dog’s neck; this may lead to a
rash or infection.
5. Check the tightness of the Receiver Collar by inserting one finger
between the end of a Contact Point and your pet’s neck. The fit
should be snug but not constricting (
5B
).
a. Allow your pet to wear the collar for several minutes
then recheck the fit.
b. Check the fit again as your pet becomes more comfortable
with the Receiver Collar.
6. Trim the collar as follows (
5C
):
a. Mark the desired length of the Receiver Collar with a pen.
Allow for growth if your pet is young or grows a thick winter coat.
b. Remove the Receiver Collar from your pet and cut off the excess.
c. Before placing the Receiver Collar back onto your pet, seal the edge
of the cut collar by applying a flame along the frayed edge.
To Re-Thread the Collar
5A
5C
5B
Slide Buckle
Ridges
The slide buckle prevents the
collar from becoming loose
around your pet’s neck.
The ridges must be facing up;
the collar will slip if it is not
properly threaded.
Summary of Contents for PIF00-15001
Page 2: ...1 800 732 2677 2...
Page 27: ...www petsafe net 27...
