www.petsafe.net 5
Allowing your pet to wear the Receiver Collar indoors may result in accidental activation of the
Receiver Collar.
While physically close to the outside door:
PET LEAVING THE HOUSE:
1. Place Receiver Collar on your pet and fit it correctly with the PetSafe logo upright facing
towards your dog’s chin, and facing away from your dog’s body as shown in Figure 6B on
page 22.
2. Turn ON the Receiver Collar by holding the MODE button down until a 2 beep tone sounds and a
green LED comes ON. Release the button. The Receiver Collar is now ON. The green light should
flash every 4 seconds.
3. Allow your pet to go outside in the Pet Area.
4. Do not allow your pet to roam inside the house with the Receiver Collar turned ON.
As close as possible to the outside door:
PET ENTERING THE HOUSE:
1. Remove the Receiver Collar or
2. Turn OFF the Receiver Collar by pressing and holding down the MODE button for 5 seconds.
The Red LED will be on during this time. The Red LED will then turn OFF with a 2 beep sound. All
Receiver LED’s will stay OFF indicating that the Receiver is OFF.
Summary of Contents for PIF00-13652
Page 2: ...2 1 800 732 2677...
Page 35: ...www petsafe net 35...
