www.petsafe.net 17
Prepare the Receiver Collar for Programming
1. Open the Receiver Handle and snap each
section into place to form a long pole.
2. Slide the Receiver Mounting Bracket
on the Receiver Collar before installing
the Receiver Mounting Bracket on the
Receiver Handle.
The Receiver Collar
must be installed with the arrow on the
Receiver Mounting Bracket pointing
toward the Receiver Collar PetSafe
®
logo
(
3A
).
3. Orient Receiver Handle so that the arrow
on the Receiver Handle is pointing up (
3B
).
4. Determine the height of your dog’s
neck above the ground on the Receiver
Handle to match the height of your
dog’s neck (
3C
). Important: If you will be
programming multiple dogs, position the
handle to match the height of your dog’s
www.petsafe.ne
t
UP
www
.petsaf
e.net
3A
3C
3B
3D
neck using the shortest dog’s measurements – closest to the ground.
5. To snap the Receiver Mounting Bracket on the Receiver Handle, place the bottom clip first at an angle.
Squeeze top tabs to connect to the handle.
6. Plug the Boundary Programming Unit into the Receiver Collar (
3D
). The cable from the BPU plugs into the
Receiver Collar charge jack (
1A
).
7. Turn ON the Boundary Programming Unit (BPU).
8. When connecting the Receiver Collar to the BPU, the BPU beeps twice.
Step
3
Summary of Contents for PIF00-13652
Page 2: ...2 1 800 732 2677...
Page 35: ...www petsafe net 35...
