![background image](http://html1.mh-extra.com/html/petsafe/basic-in-ground-fence-pig00-14582/basic-in-ground-fence-pig00-14582_product-manual_1532555014.webp)
14
1-800-732-2677
Step 6: Prepare the Receiver Collar
There are two sets of contact points that can be used on your receiver collar. Your receiver collar comes with the
short contact points installed. The longer contact points should be used on dogs with long hair. Tighten the contact
points using test light tool one-half turn beyond finger tight. Check the tightness weekly.
Insert and Remove the Battery
Note:
Do not install the battery while the receiver collar is on your pet.
This receiver collar utilizes a replaceable PetSafe
®
battery (RFA-67D-11).
This unique battery is designed to make battery replacement easier and
increase water protection.
To insert the battery, align the symbols on the battery (arrow) and receiver
collar (triangle). Use the edge of the test light tool to turn the battery
clockwise until the arrow lines up with the lock symbol on the housing (
6A
).
To remove the battery, turn the battery counter-clockwise using the edge
of the test light tool
(
6B
). Do not attempt to cut into or pry open the battery.
Be sure to discard the used battery properly. The battery life will vary
depending on how often your pet tests the system and receives a static
correction Check the receiver collar every month to ensure the battery is
working properly.
If the receiver indicator light is flashing every 4 to 5 seconds, battery
replacement is required. Remove the old battery from the receiver collar.
Discharge all power by holding the correction level button down until the
LED light is no longer illuminated. Replace with a new battery.
A replacement PetSafe
®
battery (RFA-67D-11) can be purchased by
contacting the Customer Care Center or by visiting our website at
www.petsafe.com.
Set the Static Correction Level
1. Remove the clear plastic cover with the test light tool to expose the
correction level button (
6C
).
2. With the battery installed, press the correction level button and
release when the receiver indicator light turns on
(
6D
).
3. The receiver indicator light will emit a series of flashes representing
the static correction level (e.g., 4 red flashes means level 4).
4. Increase the static correction level by pressing and releasing the
correction level button within 5 seconds of the previous series
of flashes.
5. After setting the static correction level, replace the cover to protect the
correction level button.
The static correction levels increase in strength from 2 to 5, with level 1
being tone only (no correction), and level 5 being the maximum setting.
Pressing the correction level button while the receiver collar is on level 5
will cause the receiver collar to revert to level 1. Refer to the function and
response table to choose the static correction level that best fits your pet.
The receiver collar is equipped to automatically increase the level of static
correction the longer your pet remains in the static correction zone if the
collar is set at level 2 or above.
The receiver indicator light acts as a low battery indicator, flashing every 4
to 5 seconds when replacement is required.
6C
6D
6A
6B