![background image](http://html1.mh-extra.com/html/petsafe/basic-in-ground-fence-pig00-14582/basic-in-ground-fence-pig00-14582_product-manual_1532555011.webp)
11
petsafe.com
Double Loop Boundary
• To section off only one boundary area or one
section of your yard (e.g., front property only, or
waterfront property)
• The 2 parallel sections of the double boundary
wire must be separated by a minimum of
approximately 5 ft.
from each other in order to
avoid cancelling out the signal as well as provide
an adequate boundary width (
3E
)
• A double loop layout requires twice as much wire
as a single loop layout because it doubles back
along the same path
With a double loop layout, the boundary wire starts
at the fence transmitter, advances out to the yard and
continues to form a boundary zone in one section
of your property (e.g., front property only). Then the
wire makes a U-turn back along the same path and
connects back to the fence transmitter. This forms a
boundary zone with a double wire.
Sample 3 (3E)
Front Property or Back Property Only
From the fence transmitter, run the wire to point
A
, then
to point
B
and so on (
B
to
C
to
D
to
E
to
F
). Next, make
a U-turn and follow your path all the way back to point
G
, keeping the wire separated by at least 5 ft. When
you get back to the house (
G
), make a sharp turn along
the side of the house back to point
A
. Finally, twist
the wires from point
A
and connect them back to the
fence transmitter.
Sample 4 (3F)
Front Boundary Only
From the fence transmitter, run the wire to point
A
, then
to point
B
. Make a U-turn and follow your path back
to point
A
, keeping the wire separated by at least 5 ft.
Then twist the wires from point
A
and connect them
back to the fence transmitter.
Sample 5 (3G)
Waterfront Property
From the fence transmitter, run the wire to
point
A
,
then
to point
B
. Make a U-turn and follow your path
to
C
, then to
D
, then to
E
. Next, make another U-turn
and follow the same path all the way back to point
A
, keeping the wire separated by at least 5 ft. Finally,
twist the wires from point
A
and connect them back to
the fence transmitter.
Sample 6 (3H)
Wire Loop Attached to Existing Fence
This layout allows you to include your existing fence
as part of your layout and keep your pet from jumping
out or digging under your existing fence. It reduces
the amount of wire which will need to be buried.
From the fence transmitter run the wire to point
A
,
then
to point
B
and so on (
B
to
C
to
D
to
E
to
F
). Next,
make a U-turn and follow your path all the way back
to point
A
, keeping the wire separated by at least
5 ft. Finally, twist the wires from point
A
back to the
fence transmitter.
A
C
D
E
B
5 ft.
3E
3F
3G
3H
A
C
D
E
F
B
5 ft.
A
B
5 ft.
E
F
B
Place Transmitter Inside
A
A
G
G
D
C
5 ft.