10/96
P/N 81905903860
page 5.1
M AINT ENANCE
5
Maintenance
Section 5
RCP-GPIO
5.1 General
The RCP-GPIO Control Panel is a solid state electro-mechanical device
designed to give long, trouble free service with minimum maintenance
requirements. If problems do occur, follow the troubleshooting procedure
provided. If additional technical assistance is required, refer to the general
assistance and service information in the front of this manual.
NOTICE
THIS EQUIPMENT CONTAINS STATIC SENSITIVE DEVICES. IT IS RECOMMENDED
THAT A GROUNDED WRIST STRAP AND MAT BE USED WHILE MAKING REPAIRS.
5.2 Preventive Maintenance
There is little need for performing preventive maintenance on the RCP-
GPIO Control Panel other than the normal care which should be given to
any high quality electronic equipment.
5.3 Test Equipment
The test equipment recommended for servicing the RCP-GPIO Control
Panel is listed in Table 5-1. Equivalent test equipment may be used.
EQUIPMENT
FUNCTION
Oscilloscope - 20MHz or Higher
Waveform Monitoring and Tracing
VOM - 20,000 Ohm per Volt or Higher
Voltage and Resistance Measurements
Table 5-1 Test Equipment Table
5.4 Corrective Maintenance
The following paragraphs provide information to assist the servicing tech-
nician in the maintenance of the RCP-GPIO Control Panel. The functional
description (Section 4) contains assembly and circuit level information to
help identify specific problems.
