PESA Cougar 32X32, Open Me First

Page: 92 / 179

07/96
P/N 81905903820
page 4.25
Section 4 System Connections Open-Me-First
4. Connect the Jaguar 128X128 Control System's control panels to the
Jaguar Video Frame #1's (system controller installed) port connectors
using RS485 twisted pair cables. The control panel connections to the
Jaguar Video Frame may be daisy-chained. The connection to the first
control panel in each chain must be connected as shown in Section
4.7. Terminate the end of all control panel cable runs into 200 ohms.
Refer to the Jaguar 128X128 System, Control Panel Connections,
page 4.48.
5. Connect the AC power cables to the AC line input connectors on the
Jaguar Audio Frames. Do not apply AC line power to the Jaguar
Frames until instructed to do so. Connect the external power supplies
to the Jaguar Audio Frame's DC Power Input/Output Connectors.
Remember to isolate the external power supplies as shown in Section
4.6. Refer to Jaguar 128X128 System, Audio Power Connections,
page 4.49.
6. Connect the AC power cables to the AC line input connectors on the
Jaguar Video Frames. Connect the Jaguar Video Frame #1's DC
Power Connector to MVDA Frame #1's Power Connector. Loop DC
power from MVDA Frame #1 to Video Combiner Frame #1. Connect
the Jaguar Video Frame #2's DC Power Connector to MVDA Frame
#2's Power Connector. Loop DC power from MVDA Frame #2 to Video
Combiner Frame #2. Connect the Jaguar Video Frame #3's DC Power
Connector to MVDA Frame #3's Power Connector. Loop DC power
from MVDA Frame #3 to Video Combiner Frame #3. Refer to Jaguar
128X128 System, Video Power Connections, page 4.50.
7. Connect the sync signal to the Jaguar Frames using 75 ohm coaxial
cable. Remember to terminate the signal into 75 ohms. If two separate
sync signals are to be utilized loop sync 1 to the Ref 1 Connectors on
the Jaguar Frames and loop sync 2 to the Ref 2 Connectors. Refer to
Jaguar 128X128 System, page 4.51.
4.11 Jaguar 128X128 System Connections Continued:
Connection Guide Continued: