PESA Cougar 32X32, Open Me First

Page: 86 / 179

07/96
P/N 81905903820
page 4.19
Section 4 System Connections Open-Me-First
6. Connect the sync signal to the Cougar Frames using 75 ohm coaxial
cable. Remember to terminate the signal into 75 ohms. If two separate
sync signals are to be utilized loop sync 1 to the Ref 1 Connectors on
the Cougar Frames and loop sync 2 to the Ref 2 Connectors. Refer to
Cougar 32X32 System, page 4.32.
4.9 Cougar 64X64 System Connections
The Cougar 64X64 Switching System enables the user to switch any of 64
video inputs to any of 64 video outputs. Likewise, the Cougar 64X64
Switching System enables the user to switch any of 64 stereo audio inputs
to any of 64 stereo audio outputs. Use the following guide to insure that
the Cougar 64X64 Switching System interconnections are properly con-
nected and that all cables are correctly installed.
NOTE
Do not power-up the switching system until all connections are made. Follow the System
Power-Up Procedure, Section 4.12, when powering up any Cougar or Jaguar Switching
System.
Connection Guide
Be sure to keep audio, video, and power cables separated whenever
possible. Use tie-wraps to provide proper support for each cable during
the cabling process.
1. Connect the Primary Control System Terminal to the Cougar Video
Frame #1's (system controller installed) Serial 1 Connector using a 9-
pin RS232 "null modem" cable. Connect Secondary Control System
Terminal (optional) to the Cougar Video Frame #1's Serial 2 Connector
using a 9-pin RS232 "null modem" cable. Loop the Cougar Video
Frame #1's 5-pin Control Connector to the Cougar Video Frame #2's
5-pin Control Connector using a 5-pin cable. Continue connecting the
Cougar Frame's Control Connectors together using 5-pin cables until
all of the Control Connectors on all of the Cougar Frames are intercon-
nected. Refer to Cougar 64X64 System, Control Connections, page
4.33.
Connection Guide Continued:
4.8 Cougar 32X32 System Connections Continued: