PESA Cougar 32X32, Open Me First

Page: 78 / 179

07/96
P/N 81905903820
page 4.11
Section 4 System Connections Open-Me-First
PIN NO. DESCRIPTION
1 CD
2 RX DATA
3 TX DATA
4 DTR
5 GROUND
6 DSR
7 RTS
8 CTS
9 N/C
RCP Panel Connectors
The RS485 panel port connectors allow the daisy-chained connection of
up to 127 remote control panels to the Jaguar Video Routing Switcher.
Bidirectional communications between the internally installed 3300
Controller(s) and the various models of PESA's low cost RCP control
panels are sent and received over RS485 buss.
Monitor Output Connectors
The Monitor Output Connectors provide a test signal which will be utilized
to monitor Jaguar Video Routing Switcher activity when a Output Monitor
Card is installed in the Jaguar Frame. The test signals available are moni-
tor output, combiner output, and a combination monitor/combiner output.
Reference (Sync) Connectors (1 and 2)
The sync connectors are used to connect an external sync signal to the
Jaguar Video Routing Switcher. The sync signal may be either a color
black or composite sync signal. The use of an external sync signal allows
switch changes to be accurately timed in the vertical interval. The sync
connectors are loop-thru connectors and must be terminated with 75
ohms if looping is not used.
Video Input Connectors
There are 64 BNC video input connectors located on the rear of a fully
configured Jaguar Video Routing Switcher. These connectors allow the
connection of the video sources to the Jaguar Video Routing Switcher.
The video input connectors are internally terminated into 75 ohms.
4.4 Jaguar Video Frame Connectors Continued:
Serial (CPU Link) Connectors (SERIAL 1 and SERIAL 2) Continued: