PESA Cougar 3, User Manual

Page: 17 / 88

C
OUGAR
3 V
IDEO
R
OUTER
Publication 81-9059-0660-0, Rev. B
March 2011
Proprietary Information of PESA
3-2
•
Install bottom two panel-mounting screws through holes in frame mounting bracket.
•
Install top two screws.
•
Tighten all panel-mounting screws until secure.
•
If no local control panel is used, replace front cover on frame by aligning captive screws with
captive nuts on frame mounting brackets and secure by tightening thumb screws.
•
Before replacing local control panel on video routing frame, re-attach power and Ethernet
cables to connectors on rear of panel. You may attach the Ethernet cable from the router to
either connector 1 or 2 on the control panel.
3.2 I
NSTALL
R
EAR
S
UPPORT
R
AILS
Your Cougar3 router is shipped with a Rear Rack Rail Kit. It is important that this kit be installed as part
of the mounting procedure for the frame. Major components included with the kit are shown in Figure 3-
1. Each kit consists of two rear rack rails, two rail mounting ears and four screws (not shown) to attach
rails to the frame.
Rear Rack Rail (2)
Rail Mounting Ear (2)
Figure 3-1 Rear Rack Rail Kit
Install Rear Support Rails
•
Mount router frame in equipment rack
and secure chassis.
•
Install one Rear Rack Rail to chassis at
the two Rack Rail Attachment Points
using two Mounting Screws as shown
at right.
•
Repeat on opposite side of chassis using
second rack rail and remaining two
mounting screws.
•
Figure at left shows rear of chassis with
both rack rails installed.
Rear Rack Rail
Rack Rail
Attachment Points
Mounting Screws
1RU Chassis