C
OUGAR
3
V
IDEO
R
OUTER
Publication 81-9059-0660-0, Rev. B
March 2011
Proprietary Information of PESA
3-1
Chapter 3 Installation
3.1
M
OUNT
C
OUGAR
3
R
OUTER IN AN
E
QUIPMENT
R
ACK
Although rack mounting is not a requirement for operation, the Cougar3 video router frame is designed
for quick installation in a standard 19" equipment rack. If you do choose to rack mount the router frame,
be sure that there is sufficient space behind the equipment racks to allow for signal, interconnect and
power cables; and around all sides for cooling. Use all chassis mounting holes, and tighten mounting
hardware securely by using the rack equipment manufacturer’s suggested torque settings.
Fans mounted inside of this equipment provide forced-air cooling. Do not
block airflow around these fans.
I
NSTALL
V
IDEO
F
RAME
•
Detach front cover, or local control panel, from video frame by loosening the two captive thumb
screws located on either edge of the front cover.
•
If the router is not equipped with a local control panel, pull front cover away from router frame
and set aside.
•
When removing local control panel, carefully separate control panel from frame to expose
power and Ethernet wiring on back side of panel as shown in the diagram.
•
Disconnect Ethernet cable and power cable from rear of panel and set control panel aside.
•
Insert frame assembly into equipment rack and support bottom of frame until all mounting
hardware has been installed and properly tightened.
Summary of Contents for Cougar 3
Page 88: ......
