PERSUIT DC 235 DUAL CONSOLE, Owner'S Manual

Page: 117 / 120

Fresh Water System
G-3
Appendix G
DC235
14. Switch ON the FRESH WATER PUMP breaker(s).
15. At each faucet, run about 1/2 gallon of water out of each tap (hot and cold),
then close the tap. You should be able to smell chlorine out of each tap.
16. Switch OFF the FRESH WATER PUMP breaker(s).
17. Allow the chlorine sanitizing solution to sit in the system for three (3)
hours.
A shorter time period will require a greater concentration of chlorine
sanitizing solution to disinfect the water system.
18. Switch ON the FRESH WATER PUMP breaker(s).
19. Drain the chlorine sanitizing solution by opening all faucets (hot & cold), setting
single faucets to the warm position, and empty the water tank. When the
water tank is empty turn the pump breaker(s) OFF.
20. Ensure the water system, including the water heater and pump(s), is drained
completely.
21. Fill the fresh water tank with clean, fresh water. The tank should be filled until
water runs out of the vent. (See step 5.)
22. Keeping all faucets open, switch the FRESH WATER PUMP breaker(s) ON
and empty the water tank. When the water tank is empty turn the pump
breaker(s) OFF.
23. Repeat steps 21 and 22.
24. Final fill: Fill the fresh water tank with clean, fresh water. The tank should be
filled until water runs out of the vent. (See step 5.)
25. Turn the FRESH WATER PUMP breaker(s) ON
26. Open each faucet. When a smooth flow of water is observed from each hot
and cold tap, close the faucet. When all faucets are closed, the pumps will shut
off as the system pressure increases. Any air should now be purged from the
system. Leave the FRESH WATER PUMP breaker(s) ON.