26
Slave Trigger Outputs
Two parallel slave trigger outputs are provided to switch on or off any
connected peripherals to the R200i. In the event that it is not possible to
cascade connect peripherals, two slave outputs are provided. The slave
trigger outputs are designed to accept a 3.5mm diameter male DIN plug.
The voltage rating is +12V DC level ON/0V DC level OFF.
The plug must follow the specifications as per the diagram below.
5 AC Mains Input and Fuses
An IEC-standard mains input and user accessible fuse is provided at the
rear of the unit. The AC cord set is removable.
Caution! Prior to connection to the AC mains, please check the voltage label
on the rear panel to ensure that your unit conforms to the power
supply in your area. Never attempt to connect the unit to the
incorrect voltage. Severe damage can result from applying incorrect
voltage to the unit.
The mains inlet fuses (2x) are located below the mains inlet receptacle.
For more information on fuse ratings, please refer to Chapter 18
“Specifications”.
Caution! These are the ONLY user accessible fuses.
To inspect the fuses, you must remove the mains inlet cord first.
Never replace the fuses with any other ratings other than the one
specified on the rear panel.
6 Phono Earth Connection and General Earth
Connect your optional phono input earth here.
For more information, please refer to Chapter 10 “Upgrading Your R200i”.
