41
Replacing the legrest
slide bushings
For this task the following tools are necessary:
1 Allen key 3 mm
The slide bushing in the upper section of the
legrest is attached using two screws.
Removal
1.
Set the angle of the legrest to its outermost
position.
2.
Switch off the main power switch on the control
panel.
3.
Remove one end of the legrest strap by
carefully raising the lower section of the
legrest slightly and at the same time removing
the two screws on the front of the legrest. Pull
the mounting plate out of the loop of the strap.
See the illustration below.
Once the strap is loosened the lower section
of the legrest will become loose and can be
carefully pulled downwards/forwards until the
lower section of the legrest is completely
loose.
4.
Remove the slide bushing in the upper section
of the legrest, which is attached using two
screws. See the illustration above.
5.
Remove the slide bushing in the lower section
of the legrest, and at the same time use a
suitable tool to press in the locking tabs on
the bushing, located in the hole immediately
below the top edge of the legrest. See the
illustration.
Mounting
1.
Fit the slide bushing in the lower section of the
legrest, making sure the locking tabs on the
bushing are securely fixed in the hole in the
legrest. See the illustration.
2.
Fit the slide bushing in the upper section of
the legrest using the two screws. See the
illustration above.
3.
Slide the upper and lower sections of the
legrest together, and pull the legrest strap
through the legrest mechanism. See the
illustration.
4.
Place the mounting plate in the loop of the strap
and then mount this on the front of the legrest
using the two screws. See the illustration.
Slide bushing in the lower section of the legrest
Strap mounting on the legrest
Repairs
Replacing the legrest slide bushings
Do not subject the legrest to load during
mounting or removal. Risk of crushing.
m
WARNING!
