Perlick BBR96, Service Manual, Page: 57 / 76

57 Return to Table of Contents
Back Bar Operation Installation Manual
STEP 2.
STEP 3.
STEP 4.
STEP 5.
STEP 1.
STEP 2.
Press locking mechanism. Tilt shelf and remove
from unit
Figure 8-12. Shelf Locking Mechanism
STEP 3.
STEP 4.
Tab
Spring
Screw
Detent
8.4.2 Adjusting Door Spring Tension
Tension spring is in upper track of each door.
Figure 8-11. Door Track
To increase or decrease spring tension:
• Remove Phillips screw
•
Position bracket in one of three detents
• Reinstall screw
Detent farthest from left provides the least
amount of tension.
Units are shipped from factory with springs set at
the weakest setting.
8.4.3 Torpedo Spring Adjustment
Remove doors.
Remove screw.
Feed into next notch to tighten/loosen.
Tighten screw.
8.5 Drawer & Shelf Slides
8.5.1 Shelving Adjustment
Completely empty shelf or drawer before
removing.
Open door and slide shelf out.
Reposition each bracket separately. Grasp middle
of bracket, pull front end up and out, then forward
to remove.
Place brackets at desired location and reinstall
shelf(s).
STEP 1.
Pull up spring and attached black tab.
Tools required
Tools required