UltraPort Serial Adaptors User Guide
Installing under SCO UnixWare
Page 63
Chapter 2 Installing drivers and host cards
General installation procedure for SCO UnixWare
The general procedure for installing and configuring host cards, drivers software and
associated utilities for the SCO UnixWare operating system is as follows:
1. Install any UltraPort cards you require into your system. See
Installing host cards and
cable accessories
on page
94
2. If required, install the SPEED SCO UnixWare drivers and utilities onto your system using
the procedures described in
Installing drivers and utilities
on page
64
.
3. If required, remove any host cards you want from your system. See
Removing host
cards
on page
100
.
4. Using the
Serial Manager
utility, configure the serial ports you have added to the system.
See
Configuring serial ports
on page
66
.
Your system can now use the serial adaptor cards you have installed. If required, you can
reconfigure serial ports following initial installation.
Note
Once you have installed the SPEED drivers, if you add or remove any host cards the
operating system will update the kernel accordingly using the
spdconf
program.
spdconf
is run automatically during boot up and checks to see if any host cards have
been added or removed since the last time the system was powered up. If anything has
changed the files which identify the ports, terminals and transparent printing are
updated.
