9
Perle
IRG5410/5410+
Series Router Hardware Installation Guide
Installation
Connecting the Antenna/s
The IRG5410 has three SMA female antenna connectors:
• Main Cellular antenna connector
• Rx Diversity antenna connector
• GNSS antenna connector
1. Connect your cellular antenna to the SMA cellular antenna connector labeled
Main
2. Connect your GPS antenna to the SMA GPS antenna connector labeled
GNSS.
3. Mount the GPS antenna where it has a good view of the sky (at least
90
⁰).
4. Connect the diversity antenna to the SMA diversity antenna labeled
Diversity
Connecting to the Ethernet Port
The Ethernet RJ45 port provides the standard Ethernet interface speeds of 10/100/1000 Mbps through
twisted pair (UTP) cables of up to 100 meters (328ft) in length. Cat5e or Cat6 cables are
recommended for 1000 Mbps connections.
Connecting to the Serial Port
The serial port has a 9-pin female port connector that allows you to directly connect to most
computers or devices with a standard serial straight-through cable.
It can be used for:
• Connecting a serial device
• Connecting as a console port
• As a GNSS output device
Warning: For Zone 2 and/or Class I, Division 2 hazardous location applications. Antennas intended for use with
the product must be installed within the end use enclosure. For remote mounting of the antennas in unclassified
or classified locations, routing and installation of the antennas shall be in accordance with the appropriate
location regulations.
Note:
When attaching the antennas to the SMA connectors hand tighten only (do not use tools to tighten
(maximum torque is 7Kgf-cm/1.1 N-m(10 in-lb).
Note:
When connecting to a DCE device, a crossover cable is needed.
Female Serial Pin out
Name
Pin
Description
Type
DCD
1
Data Carrier Detect
OUT
