Accessories 455
Installing a MicroSIM card into your SDS L
Installing a MicroSIM card into your SDS L
The IOLAN SDS L requires that a MicroSIM (3FF) card be installed in the unit. This MicroSIM card
will be provided to you from your network provider/carrier.
1.
Removed the screws from the side of the SDS L unit, then remove the cover plate.
2.
Insert your MicroSIM card into the slot. The MicroSIM card will fit only one way (do not force
the MicroSIM card in or you could damage your SDS L). Gently press the MicroSIM card
forward until you hear it click into place within the slot.
3.
Replace the cover plate and secure it to the SDS L with the screws.
4.
Screw each of the antennas to the SDS L. (hand tighten only - do not use tools to tighten)
5.
Connect power to the SDS L.
.
6.
Configure your SDS L with your network parameters. See
for configuration options.
Inserting SFP modules into SPF slots
The IOLAN SCS16C-DSFP requires that you install an SFP module/s into the SFP slot/s on the back
of the IOLAN
Compatible SFP’s are:
z
Various SFP’s supporting 1000Base X standards in various wavelengths and cable types.
z
SFP’s with SGMII interface for either 10/100/1000 Mbit copper or 100 Mbit fiber connections.
1.
Align the SFP module in the front of the SFP slot to establish alignment.
2.
Insert the module and push inwards with your thumb until you hear a click. Do not force the SFP
in. SFP modules are keyed so you can only insert in one way.
3.
If the SFP module is equipped with a clasp, ensure the clasp is in the locked position. The
appropriate fiber cable can now be connected to the SFP module. Replace the cover plate and
secure it to the SDS L with the screws.
Note:
To verify that your MicroSIM card is correctly installed:
From the CLI command prompt run the show command.
SDS L#show wwan status
SIM
ICCID 89302720396916966778
IMSI 302720391780097
PIN retry counter 5
MicroSim Card
