182
Serial Port Profiles
Idle Timeout
Use this timer to close a connection because of inactivity. When the
Idle
Timeout
expires, the IOLAN will end the connection.
Range:
0-4294967 seconds (about 49 days)
Default:
0
seconds so the port will never timeout
Session Timeout
Use this timer to forcibly close the session/connection when the
Session
Timeout
expires.
Default:
0
seconds so the port will never timeout
Range:
0-4294967 seconds (about 49 days)
Session Strings
Controls the sending of ASCII strings to serial device at session start as
follows;
z
Send at Start
—If configured, this string will be sent to the serial device
on power-up of the IOLAN, or when a kill line command is issued on this
serial port. If the "monitor DSR" or "monitor DCD" options are set, the
string will also be sent when the monitored signal is raised.
Range:
0-127 alpha-numeric characters
Range:
hexadecimal 0-FF
z
Delay after Send
- If configured, will inset a delay after the string is sent
to the device. This delay can be used to provide the serial device with time
to process the string before the session is initiated.
Range is 0-65535 ms
Default:
10 ms
Dial Timeout
The number of seconds the IOLAN will wait to establish a connection to a
remote modem.
Range:
1-99
Default:
45 seconds
Dial Retry
The number of times the IOLAN will attempt to re-establish a connection with
a remote modem.
Range:
0-99
Default:
2
Dial In
If the device is remote and will be dialing in via modem or ISDN TA, enable
this parameter.
Default:
Disabled
Dial Out
If you want the modem to dial a number when the serial port is started, enable
this parameter.
Default:
Disabled
