Illustration 75
g06597104
(1) Fuel priming switch
1.
The fuel system can be primed from the key switch
or from a remote mounted switch (1).
2.
Ensure that any fuel isolation switches to the
engine are in the open position to allow the correct
fuel flow.
3.
Turn the fuel priming switch (1) to the ON position.
Hold the fuel priming switch in the ON position for
2 minutes.
4.
Attempt to start the engine.
5.
If the engine cannot be started, or if the engine
runs rough, or if the engine misfires, or if the
engine smoke, stop the engine. Repeat Step 3
through Step 5.
The fuel system can also be primed by using the key
switch. Turn the key to the ON position for 2 minutes.
After 2 minutes the fuel system should be primed. If
necessary, by cycling the key switch the system will
prime again for 2 minutes.
i08246229
Fuel
System
Primary
Filter
-
Replace
Fuel leaked or spilled onto hot surfaces or electri-
cal components can cause a fire. To help prevent
possible injury, turn the start switch off when
changing fuel filters or water separator elements.
Clean up fuel spills immediately.
NOTICE
Ensure that the engine is stopped and the battery is
isolated, before any servicing or repair is performed.
Illustration 76
g06597507
Typical example
M0122761
79