8.
Install guards (1) and restore electrical power to
the engine.
Replace
Refer to “Disassembly and Assembly Manual”V-Belts
(Fan Drive V-Belts) - Remove and Install for more
information.
i08301796
Belts
-
Inspect/Adjust/Replace
(5008-E30TAG
Engines
Only)
Inspection
1.
Isolate the electrical supply to the engine.
2.
Visible inspect fan guards for ware or damage.
Repair as necessary.
Illustration 44
g06022928
Typical example
3.
Remove the inspection guard (X) and inspection
guard (Y).
Illustration 45
g02025316
Typical example
4.
Inspect the belts (1) for cracks. Inspect the belts
for contamination. If necessary, replace the belts.
Refer to “Replacement” for more information.
5.
The belt tension must be checked at position A.
Use a suitable spring balance and a suitable
straight edge to check the belt tension.
6.
The belt tension should be 62 N (14 lb) with a
maximum deflection at position B of 16 mm
(0.63 inch).
7.
Adjust the belts if the belt tension exceeds or is
below 62 N (14 lb). Refer to “Adjustment” for more
information.
8.
Install the inspection guard (X) and inspection
guard (Y).
9.
Restore the electrical supply to the engine.
Note:
Check that the pulleys are securely fitted.
Visually check pulleys for angular misalignment,
composite misalignment, and axial misalignment.
Refer to your Perkins distributor for more information.
Adjustment
1.
Ensure that the electrical supply to the engine is
isolated. As required, remove the guards.
M0122761
59