Perkins 103-06, Workshop Manual

Page: 14 / 80

External Oil Pipe
Fuel Lift Pump
PB010
A. Loosen and remove two banjo bolts at cylinder A. Loosen two cap screws and lift from its bore;
block main oil galley and cylinder head remove joint.
assembly.
B. Remove clamp from fuel injection pump.
PB011
PB008
Cylinder Head Assembly
A. Loosen cylinder head bolts starting from the
centre, in a circular pattern using several
steps of equal torque. Remove head.
PB009
Tappets
A. Pull tappets from the machined bores in cylinder
block.
Fuel Injection Pump Assembly
A. Remove two bolts and nuts securing fuel injec-
tion pump to cylinder block. Slowly lift and posi-
tion fuel injection pump until access to link snap
pin is gained.
B. Remove snap pin and remove link from control
rack. Remove fuel injection pump and shim
pack.
NOTE: Injection timing is determined by the
shim pack between fuel injection pump flange
and cylinder block mounting face. The thickness
and number of shims should be checked and
recorded to aid re-assembly.
P8012