PerkinElmer STA 8000, Installation And Hardware Manual

Page: 48 / 64

48 . STA 8000 Installation and Hardware Guide
Connect the STA 8000 Components
The computer and optional printer should already be connected together and the Pyris
software already installed. To complete the connection of the system components, the
STA 8000 has to be connected to the computer.
CAUTION
ATTENTION
Make sure all components are turned off and unplugged before you
begin.
Assurez-vous que tous les composants sont éteints et débranchés avant
de commencer.
The image below shows the connections on the STA 8000:
1. Connect one end of the RS-232 cable to the back of the STA 8000.
2. Connect the other end of the RS-232 cable to COM1 on the back of the computer.
3. Connect the printer cable to the USB port.
4. Connect the analyzer, printer and computer power cords to AC outlets.
5. Once the system connections are made, switch on the system in the following order:
– Computer
– STA 8000
– Printer
6. Turn on the purge gas supply, and the water for the STA 8000 cooling system or any
other accessories for the cooling device you are using.