Peri MULTIPROP, Instructions For Assembly And Use, Page: 34 / 58

32
MULTIPROP System
Instructions for Assembly and Use – Standard Configuration
A7 Dismantling
Dismantling
Horizontal dismantling is preferred.
Vertical dismantling, however, is
possible.
– Ensure stability during
dismantling!
– Avoid load concentrations by
lowering the props evenly!
– Use Spanner HD to release
loads > 60 kN!
Vertical dismantling
1. Temporarily secure the tower against
tipping over, see A5.
2. Release adjusting nuts using the
Wing Nut Spanner HD.
3. Lower the MULTIPROP Tower.
4. Remove formwork structure.
5. Dismantle tower from top to bottom.
Remove horizontal mounting security
only when the stability has been
ensured.
(Fig. A7.01)
Horizontal dismantling
1. Move out the lowered MULTIPROP
Tower from underneath the concreted
slab.
2. Attach crane lifting gear.
3. Slide in inner tubes on one side, see
A3 with multiple number of legs.
4. Set down MULTIPROP Tower on level
ground. (Fig. A7.02)
5. Dismantle the MULTIPROP Tower.
– If structural bracing has been in-
stalled, it is sensible to lower the
MP Towers on the uppermost props.
– The Wing Nut Spanner HD allows an
effortless and silent release of the
adjusting nuts – even if the props
are fully loaded.
Fig. A7.02
Fig. A7.01
Concreted slab
AuV MULTIPROP EX.indb 32 07.01.16 11:57