Quick.us /
Performance Variable 19
13
Attach the steering toggles according to the rig manufacturer’s instructions. If such
instructions haven’t been provided, follow these procedures:
1)
Route the steering line through the guide ring on the riser. Then route it through
the grommet in the toggle, starting from the side with Velcro. Wrap the steering line
around the outside of the toggle, over the grommet. The mark should be 1¼” (3 cm)
from the side as shown.
2)
Slide the line off the toggle and tie a loose overhand knot in the folded line.
3)
Now slide the line back over the toggle and tighten the knot as shown. The idea
is to use the width of the toggle as a measuring guide for the size of the loop. The
mark on the line should be just to the outside of the knot, away from the toggle.
4)
Pull the knot up to the grommet. Daisy chain the excess end of the steering line
as shown. Don’t cut the extra off; you may wish to change the brake setting slightly
at some time.
Attaching Toggles
Factory finished toggle loop
Unfinished toggle loop
Overhand knot (see #2 above)
Summary of Contents for Quick 113
Page 6: ...Quick us Performance Variable 6 1b...
Page 7: ...Quick us Performance Variable 7 1c...
Page 12: ...6 Parts List 12...