![background image](http://html.mh-extra.com/html/perel/whpc01/whpc01_user-manual_1528697006.webp)
WHPC01
Rev
03
27.04.2010
©Velleman nv
6
•
Unscrew the top of the detergent injector and fill the injector with detergent.
•
Screw the top back on.
•
Remove the lance from the gun.
•
Attach the detergent injector to the gun (fig.
B7
).
•
Apply detergent so it thoroughly covers cleaning surface. Apply from bottom to top to prevent detergent from
sliding down and streaking.
•
Allow detergent to remain on the surface for a few minutes. This is a good time to use a brush to lightly scrub
heavily soiled areas. Never allow detergent to dry on the cleaning surface.
•
Remove the detergent injector from the gun.
•
Rinse detergent from surface.
Remember to rinse the detergent injector with water after use!
Final Rinse
Start from the bottom up and make sure all detergent is removed from the target surface.
Shut-Down
•
Make sure all detergent is flushed from the system.
•
Turn off the motor.
•
Turn off the water supply.
•
Now trigger the gun to depressurise the system.
•
Always wipe every surface of the pressure cleaner with a clean, damp cloth after use.
CAUTION:
NEVER turn the water supply off before turning the motor off as this could seriously damage the
pump and/or the motor.
WARNING:
NEVER disconnect the high-pressure discharge hose from the machine while the system is
pressurised. To depressurise: turn off the motor and then the water supply and squeeze the
trigger 2 to 3 times.
7.
Tips to Prolong the Life of your High-Pressure Cleaner
•
NEVER store the pressure cleaner outdoors or where it could freeze. This would seriously damage the pump.
•
Never operate the unit without water.
•
The pressure cleaner is not meant to pump hot water. NEVER connect it to a hot water supply as it will
significantly reduce the life of the pump.
•
NEVER allow the unit to run for more than one (1) minute without spraying water. The resulting heat build-up
will damage pump.
8.
Troubleshooting
Symptom
Possible Cause
Corrective Action
Unit doesn’t start
Unit is pressurised
Squeeze trigger on gun
Plug is not well connected or
electric socket is faulty
Check plug, socket and fuse
Extension cord too long or wire
size too small
Remove extension cord
Mains voltage supply too low
Check that main supply voltage age is
adequate
Pump doesn’t reach necessary
pressure
Water inlet filter is clogged
Clean water inlet filter
Pump sucking air from hose
connections
Check that connections and locking ring are
properly tightened
Nozzle worn or wrong size
Contact your dealer
Unloader clogged or worn
Contact your dealer
Valves clogged or worn
Contact your dealer
Fluctuating pressure
Pump sucking in air
Check that hoses and connections are tight
Clogged nozzle
Clean with tip cleaner (see higher)
Valves dirty, worn or stuck
Contact your dealer
Water seals worn
Contact your dealer
Motor stops suddenly
Extension cord too long or wire
size too small
Remove extension cord
No detergent suction (units with
attachable injectors)
Detergent injector clogged Clean
injector with warm water
Replace
injector
Unit starts to smoke
Overheated, overloaded or
damaged motor
Switch the unit off and contact your dealer
9.
Technical Specifications
working pressure / max. pressure
70 bar (1000 psi) / 105 bar
flow 5
L/min
power 1400
W
working voltage
230 VAC/50 Hz
dimensions
390 x 270 x 260mm
weight 6
kg