Assembly and Operation Manual
If at the
“Verification”
mode expiration the ACS controller does not receive the “Card
captured” signal from the reader it will not unblock the operating device. The red indicator
and sound signal is switched on for 2 sec. on the indication module at that. After that the
ACS controller switches back to the “Control” mode. The missing of the signal “Card
captured” shows that the card has not fallen into the card container. The reason can be
blocking of the card container, card capture reader failure or if the card was not inserted
into the slot.
Attention!
If the passage was not authorized the visitor shall take the card out of the slot and
refer to the entrance operator.
11.2 Presenting a permanent card
The permanent card is presented to the top cover of the card capture reader.
At the permanent card presentation, considering that card is operative and its validity
corresponds to the time of passage, the ACS controller sends a signal to unblock the
operating device for the time set by its
Passage waiting time
parameter. The green
indicator on the indication module showing authorization of passage is switched on at that.
After the passage through operating device is made or its
Passage waiting time
is lapsed
the ACS controller switches back to the “Control” mode and blocks the operating device.
In case of the ban on passage (card fault, card invalidity corresponding to the time of
passage or access wright) the red indicator and sound signal is switched on for 2 sec.
After that the ACS controller blocks the operating device and switches back to the
“Control” mode.
11.3 Blocking and resume of card capturing
On cards capturing the container gets full. When it is full further cards capturing is blocked
till the captured cards are extracted from the container. In this case the card capture
reader generates the
“Fault”
signal for the ACS controller.
At blocking of the guest card capturing the following indication is present: at first blinking of
the green and red indicators, after that switch on for 2 sec. the red indicator and sound
signal. After that
the ACS controller switches back to the “Control” mode and the yellow
LED indicator lights up on the indication module.
Note:
While the capturing of guest cards is blocked the permanent cards are operated in
normal order.
To resume capturing of guest cards it is necessary to extract the full container from the
card capture reader and empty the cards (the order of the container extraction and
installation is described in Clause 11.4.
If the container is free from cards but the card capture reader is still blocked a likely reason
for this could be failure of the card capture reader units. It is recommended to apply to the
PERCo Technical Support Department.
11.4 Removal and installation of the card container
To take out the card container (9) from the card capture reader proceed as follows:
1 Switch off the power supply of the card capture reader.
2 Insert the key into the card container lock (8).
3 Turn the key all the way (
open
the lock).
4 Tilt the card container.
18
