IC-02.1 card capture reader
the panel to the cover (4). Use the cables given in Table 1. The length of the cables
ends that remain inside the card capture reader after their pulling should be enough
for their further connection. It is recommended to secure all cables on the internal
sides of the base (1) with cable ties and self-adhesive cable tie mounts
1
.
Attention!
Be extra cautious and careful when carrying out further works, make sure the card
capture reader does not fall until it is fixed in place.
Figure 6.
Base (1) bottom view:
central hole
Ø
30 mm is intended for cables entry
8. Put the base (1) of the card capture reader to
A
zone. Match four holes in the base
with holes in the mounting surface. Fix the card capture reader with anchor bolts,
controlling its vertical position with a level gauge.
9. Pull the cables in the corresponding electric raceways.
10. Connect the cables to the card capture reader control board located in its upper
part from the panel (3) side. Make connection according to wiring diagram (see
Figure 7).
11. Set the panel (3) into operating position and fix it with screws. Install the card
container (9) using the lock (8). Install the cover (4) by carefully pressing it until it is
fixed by clamps.
12. Check accuracy and integrity of all cables laid. Check accuracy and reliability of all
electrical connections of the card capture reader with power supply and ACS
controller.
13. On completion of checking the card capture reader is ready for operation.
1
Cable ties and self-adhesive cable tie mounts are not included in the set of delivery.
13
