PEQUEA SuperSpread PTO 135, Operator'S Manual, Page: 18 / 28

Lubrication Cont.
16
CAUTION: DO NOT ATTEMPT TO CLEAN OR ADJUST THE MACHINE WHILE IT
IS RUNNING.
Lubricate wheel hubs every 100 loads. Figures 16-1,2
Remove cotter key and turn hub nut counter
clockwise. Apply slight pressure on top face of
tire to loosen bearing. Remove bearing, clean
and pack with new, clean grease. Replace bear-
ing, and tighten nut fully. Do not over tighten. Attempt to spin tire. If it is sluggish, turn nut
counter clockwise at least
1 /
6
turn but no more
than 1 /
2
turn. Replace cotter key and bend ends.
Replace hub cap.
Figure 16-1
L o
o s
e
n
Lubricate the conveyor drive chain with SAE
#03 oil or similar lubricant at least twice yearly,
more often if the spread material is of high acid
nature or if the machine is stored outside. Regular
lubrication of the conveyor chain will substantially
increase its life.
Lubricate all grease fittings (there are 4)
according to instructions found on page 15.
Fittings require lubrication on each end of the
web front roller and on each end of the web rear
roller.
Figure 16-2