Universal Temperature Converter KCD2-UT2-(Ex)1
Configuration tools
81
39
68
20
13
-10
EN - 11
EN
6
Configuration tools
The temperature transmitters KFD2-UT2-(Ex)*(-1) are parameterised
using the configuration tool
PACT
ware
TM
.
The
PACT
ware
TM
on-line version can be downloaded free of charge
from our internet page www.pepperl-fuchs.com/pa under software/
PACTware. Licensed versions are available at a charge.
The device-independent features of the software are described in the
"
PACT
ware
TM
process automation configuration tool" manual, which
can also be downloaded free of charge in several languages from our
internet page www.pepperl-fuchs.com/pa under software
/
PACTware.
In the following, you will find the device-specific information for the
temperature converters.
6.1 Installation and connection with the device
Install the
PACT
ware
TM
on a PC. The system requirements and the installation steps can be found
in the "
PACT
ware
TM
process automation configuration tool" manual.
Connect the PC and the UT2 using the K-ADP1 cable. This cable can be ordered as an accessory.
If possible, please use the new version of the cable (part number 181953, length of the jack plug
14 mm). When using the old version (length of plug 18 mm), the jack plug will project out approx.
3 mm. However, this does not affect the function.
Connect the cable with the jack plug to the RS 232 interface on the front panel of the UT2. At the
PC connect it to the 9-pin or the 25-pin connector of a free serial interface.
Start the
PACT
ware
TM
as described in the "
PACT
ware
TM
process automation configuration tool"
manual.
Pressing the plug in by force may damage the end devices.
Attention
