Quick Start Functions
Connect Ethernet
Connect an RJ45 cable from an Internet-enabled router to a port on the Peplink SD Switch.
The uplink port can be either an ethernet or SFP port.
Connect an RJ45 cable from any client device to a port on the Peplink SD Switch.
Connect SFP/SFP+
Remove the protective plastic cover from the SFP/SFP+ port.
Plug a compatible fiber module into the SFP/SFP+ port.*
A list of compatible and tested SFP/SFP+ modules can be found in the following Google sheet:
https://docs.google.com/spreadsheets/d/1Vx7hZTe-gHMlVal9_0R2H1MpRjDrA05duS3nNMGBwf0/edit?u
sp=sharing
The list of SFP/SFP+ modules is not limited to the above list, but haven’t been tested.
*
“SFP+" for 24/48 ports model
“SFP" for 8 and 16 ports model.
Connect to the Management Port
The management port is designed for Out-of-Band management.
The SD-Switch can be managed via this port only by default.
The management Port IP address is 192.168.1.254/24
Connect an RJ45 to the management port and a client device.
Configure the client device with an IP address in the 192.168.1.0/24 range.
Open a web browser and enter the default IP address of the management port in the address field of the
web browser ( http://192.168.1.254) to access the web interface of the Peplink Switch.
Copyright & Trademarks
Specifications are subject to change without notice. Copyright © 2020 Pepwave Ltd. All Rights Reserved. Pepwave and the Pepwave logo are
trademarks of Pepwave Ltd. Other brands or products mentioned may be trademarks or registered trademarks of their respective owners.
