peplink Pepwave MAX Series, User Manual

Page: 47 / 218

https://www.peplink.com Copyright @ 2021 Pepwave
bands (frequencies) .
When set to Manual, you can manually select the bands (frequencies) the SIM will connect to.
Data Roaming
This checkbox enables data roaming on this particular SIM card. When data roaming is enabled
this option allows you to select in which countries the SIM has a data connection. The option is
configured by using MMC (country) codes.Please check your service provider’s data roaming
policy before proceeding.
Authentication
Choose from PAP Only or CHAP Only to use those authentication methods
exclusively. Select Auto to automatically choose an authentication method.
Operator Settings
This setting alloes allows you to configure the APN settings of your connection. If Auto
is selected, the mobile operator should be detected automatically. The connected
device will be configured and connection will be made automatically. If there is any
difficulty in making connection, you may select Custom to enter your carrier’s APN ,
Login , Password , and Dial Number settings manually. The correct values can be
obtained from your carrier. The default and recommended setting is Auto .
APN / Login /
Password /
SIM PIN
When Auto is selected, the information in these fields will be filled automatically. Select
Custom
to customize these parameters. The parameter values are determined by and
can be obtained from the ISP.
Bandwidth
Allowance
Monitor
Check the box Enable to enable bandwidth usage monitoring on this WAN connection
for each billing cycle. When this option is not enabled, bandwidth usage of each month
is still being tracked but no action will be taken.
Action
If email notification is enabled, you will be notified by email when usage hits 75% and
95% of the monthly allowance. If Disconnect when usage hits 100% of monthly
allowance is checked, this WAN connection will be disconnected automatically when
the usage hits the monthly allowance. It will not resume connection unless this option
has been turned off or the usage has been reset when a new billing cycle starts.
Start Day
This option allows you to define which day of the month each billing cycle begins.
Monthly
Allowance
This field is for defining the maximum bandwidth usage allowed for the WAN
connection each month.
Signal Threshold Settings
If signal threshold is defined, this connection will be treated as down when a weaker than
threshold signal is determined.
The following values are used by the threshold scale: