Appendix A: Post Message
________________________________________________________________
________________________________________________________________
41
Ö
DISPLAY SWITCH IS SET INCORRECTLY
Display switch on the motherboard can be set to either monochrome or color.
This indicates the switch is set to a different setting than indicated in Setup.
Determine which setting is correct, and then either turn off the system and
change the jumper, or enter Setup and change the VIDEO selection.
Ö
DISPLAY TYPE HAS CHANGED SINCE LAST BOOT
Since last powering off the system, the display adapter has been changed.
You must configure the system for the new display type.
Ö
EISA Configuration Checksum Error
PLEASE RUN EISA CONFIGURATION UTILITY
The EISA non-volatile RAM checksum is incorrect or cannot correctly read
the EISA slot. This can indicate either the EISA non-volatile memory has
become corrupt or the slot has configured incorrectly. Also be sure the card
is installed firmly in the slot.
Ö
EISA Configuration Is Not Complete
PLEASE RUN EISA CONFIGURATION UTILITY
The slot configuration information stored in the EISA non-volatile memory is
incomplete.
F
When either of these errors appear, the system will boot in ISA mode, which
allows you to run the EISA Configuration Utility.
Ö
ERROR ENCOUNTERED INITIALIZING HARD DRIVE
Hard drive cannot be initialized. Be sure the adapter is installed correctly and
all cables are correctly and firmly attached. Also be sure the correct hard
drive type is selected in Setup.
Ö
ERROR INITIALIZING HARD DISK CONTROLLER
Cannot initialize controller. Make sure the cord is correctly and firmly
installed in the bus. Be sure the correct hard drive type is selected in Setup.
