76570EM 53
there is a possibility that dust enters into the inside of CCD.
(1)Cut the Clean wipe-P about 1/4 (50x105mm) and hold the Clean wipe-P 7-8mm width.
(2) Turn the main SW to ON and remove the lens.
(3) Set [Sensor Cleaning] on the Main menu to ON.
(4) Select [Mirror up] on the [Sensor Cleaning] screen by the four-way controller.
(5) Press the OK button. The mirror is locked in the up position.
(6) Dip Clean wipe-P: 95901 A15 in the Solvent.
(7) Wipe the surface of CCD from upper left to bottom and repeat 3-4 times until lower right
.
You can confirm dust or trace of wipe by cleaning at under the bright light source.
(8) Turn off the power and return to step (1) of the confirmation then confirm dust.
[Supplement] Dust on the CCD
Cause of dust into the camera.
→
Dust enters from outside of the camera when changing the lens.
Dust stick by moving mirror or shutter.
According to CCD characteristic the static electricity occurs when taking a picture and so the
condition is dust stick easily. Besides customer can find dust
easily by viewing image by the computer.
It is very difficult to remove dust completely therefore, before cleaning the camera, explain to
customer for cleaning as much as possible.
24-7. Default setting
*This setting is initialized camera as condition of product shipment.
[Required equipment] SD card (for Default setting), AC adaptor
(1) Turn the main SW to OFF and then connect the AC adaptor to the camera.
(2) Insert the SD card (for Default setting) into the camera.
(3) Turn the main SW to ON while the SD card cover is opened. The Default setting will start with
blinking the access lamp.
(4) After COMPLETE… is appeared, turn the main switch to OFF and remove the SD card from
the camera.
(5) [Initial Setting] will be displayed on the LCD monitor when the main SW is turned ON.
24-8. FW version up
Version up latest FW if necessary.
Refer to [FW Firmware]
1/8
CCD
Frame
